You will need"
Beads
Earring hoop
Ear wire
Step-by-step for hoop earrings
- Gently pull the wire at the top of the hoop until it clears the metal clasp and thread on thebeads.
- Carefully replace the wire into the metal clasp at the top of the hoop.
- Open the loop of the ear wire and thread on the hoop. Close the loop of the ear wire.
Dangling Earrings
You will need"
Beads
Eye pins
Head pins
Ear wire
Step-by-step for dangling earrings
1-Decide on the pattern of beads to be used.
2-Thread the beads onto an eye pin or a head pin (an eye pin if you are going to attach another bead to it, a head pin if that is the last bead to dangle) and form a loop.
To make a loop
Thread bead onto eye pin or head pin
- Using the flat nose pliers, bend the open end of the eye pin at right angles, as close to the bead as possible
Using the wire cutter, cut the bent end of the eyepin leaving approximately 6-7mm of wire. The length needed to form the loop depends on amount of wire needed to create a loop to match the loop already in place, at the other end Using the round nose pliers, grab the very end of the bent end of the eyepin, about 5mm from the tip of the pliers. The exact position on the pliers depends on the size of loop required to match the loop already in place at the other end Holding the tip of the wire, roll the pliers along the wire, forming a loop which is centred over the hole in the bead
- Attach beads, in the chosen sequence, by opening the loop of one bead and attaching to the loop of the next bead.
- Finish by attaching the beads to the loop of the ear wire.
To buy beads and other art and craft supplies Online , visit http://www.craftandtrimmingsonline.co.uk/ - suppliers of Quality Beads, Beaded Trimmings, Curtain Tie backs, Craft Glues and Adhesives!
No comments:
Post a Comment